I have the same problem in the Matrix.
It happens most often with larger and more complex models. Now I need to model pendant 4x4cm and 200x 2 mm and 450 diamonds prongs.
Model in 7 Metrix has slowly turn the mesh and can not be repaired.
Constantly reports that the system is low on memory.
---------- Post added at 11:13 PM ---------- Previous post was at 11:09 PM ----------
I was told it's a problem Rhino 4 32bit. He works only with 4GB RAM.
Although memory as I have 16GB RAM, so it does not use 32bit system. It is able to 64bit system.
I wanted to fix mesh in Rhino 5, and I ran into the same error. After working for a while I reported out of memory and bit.
---------- Post added at 11:18 PM ---------- Previous post was at 11:13 PM ----------
I suffer with it constantly. Almost every other model that happens.
I have not found yet any solution.
Just consult frequently save and restart the Matrix.
Someone wrote here, buy the full version of Matrix 7th
But why, if it can not handle complex models handle.
And then he is so terribly expensive $ 6,500
---------- Post added at 11:23 PM ---------- Previous post was at 11:18 PM ----------
And how did you do?
Just by you increased the RAM to 32 gigabytes
Solve the problem, Matrix is therefore not a bug with memory reporting?
Write me what is your exact kofigurace PC